31 Jul 2016

Here’s “boost creep”: an uncontrolled increase in manifold pressure, seen here as the light blue “MAP” trace at the center of the figure. This is with a 4-lb spring which in a perfect world limits boost to 4 psi, but the manufacturer notes that actual boost will vary engine to engine. In mine it’s about 7 psi (150kpa), which is fine if it stays there. It holds pretty well until about 5000 rpm, but then the exhaust gas volume becomes too much for it to vent off and the turbine speeds up and increases boost. I let off the gas when it hit 13 psi at 6100 rpm because it was trending upward pretty fast (and because I was already going 84 mph). The right way is to do all this on a dyno – maybe after boost is under control.

Parts were (again) ordered to change to a dual 38mm wastegate setup. I figure that worst case, the two don’t do the job and the header has to be redesigned, and both will still be needed in that case so they aren’t a waste. Somewhat related, I found this funny quote which is a pretty good description of what it’s like to live with a turbo engine, where:

… it’s like having a cokehead pornstar girlfriend. There’s going to be unparalleled excitement and thrills, but a lot of unexplainable downtime and a likely violent ending that leaves you broke and insane…